MFE 710

• MFE 710 can be used in all fabrication methods. but is especially adapted to meet the requirements of filament winding. centrifugal casting. hand lay - up and spray - up applications.
• MFE 710 is suitable for high temperature water. acid and salt solutions. Low peak exotherm allows the manufacture of thick laminates.

• Typical property values only. not to be construed as specifications
• Catalyst system:

100g resin with 1.5% Butanox M50
2.5% Accelerator NL - 49P
0.3% DMA (10%)

• Unopened drum with no additives. promoters. accelerators. etc.
• Cure schedule: 24 hours at 20℃; 4 hours at 100℃
• Maximum stress: 1.8 MPa
• Postcure: 24hrs at 20℃ followed by 2hrs at 120℃

200kg per drum.

Recommended Storage:

• Drums - Store at temperatures below 25°C.
• Storage life decreases with increasing storage temperature.
• Avoid exposure to heat sources such as direct sunlight or steam pipes.
• To avoid contamination of product with water. do not store outdoors.
• Keep sealed to prevent moisture pick - up and monomer loss. Rotate stock.

Safety and Handling Consideration:

• This resin contains ingredients which could be harmful if mishandled.
• Contact with skin and eyes should be avoided and necessary protective equipment and clothing should be worn.