Ultimate DryStone™

Mixing Instructions
Mix Preparation

Use potable water at temperatures between 70 °F (21 °C) and 100 °F (38 °C). Because variations in slurry (USG Ultimate Drystone Casting Media and water mixture) temperature produce variations in set time, it is important to keep both the USG Ultimate Drystone Casting Media and water in a stable temperature environment prior to use. The higher the temperature of the slurry, the shorter the set time. Conversely, the lower the temperature of the slurry, the longer the set time.

Mixing

• Sift or strew USG Ultimate Drystone Casting Media into the water slowly and evenly; start mixing immediately.
• Mixing the plaster slurry is one of the most important steps in producing plaster molds with maximum strength, absorption, hardness and other important properties.
• IMPORTANT – USG Ultimate Drystone Casting Media must be mechanically mixed with a batch process. Proper blade and bucket dimensions are important for obtaining the best batch mix (See USG IG503 Plaster Mixing Procedures for details).
• Longer mixing times result in higher mold strength and shorter set times.

Pouring

• To prevent air entrainment and provide a uniform, smooth surface, careful pouring of USG Ultimate Drystone Casting Media slurry is necessary. Agitation of the filled mold is a further step used to prevent air at or near the mold surface. Whenever possible, USG Ultimate Drystone Casting Media slurry should be poured carefully in the deepest area so that the slurry flows evenly across the surface of the case mold.
• Pouring a large amount of slurry directly on the face of the case mold may result in slight densification of the USG Ultimate Drystone Casting Media mold at the point where it strikes the surface of the case. This produces a hard spot, giving uneven absorption.
• USG Ultimate Drystone Casting Media can be used with most mold materials such as silicone, latex or urethane-type molds.
• To prepare the mold, make sure it is clean, then dip the mold or spray it with a suitable mold rinse. Using a steady rate, pour the USG Ultimate Drystone Casting Media slurry into one corner of the mold or into the lowest point and allow the slurry to rise and seek its own level. Continue pouring until the mold is full. To minimize air entrainment, mechanically vibrate or shake the mold or the surface onto which the mold is placed. Do not vibrate for more than 30 seconds.
• Demold USG Ultimate Drystone Casting Media after it reaches peak heat (approximately 30 minutes after set).

Drying

All casts should be air dried as quickly as is safely possible after manufacture so that maximum physical properties can develop. Dry to a constant weight. To aid in the drying and cooling down process, remove the hardened USG Ultimate Drystone Casting Media cast from the mold, or loosen the mold walls and allow air to circulate the cast.

Finishing

If trimming is required, do so immediately after demolding. USG Ultimate Drystone Casting Media products can be decorated approximately 2-4 hours after set time.